Honda Catalytic Converter Removal and Installation Procedures

Honda Catalytic Converter Replacement Procedures. The catalytic converter on a Honda is an emissions element located within the exhaust system. A catalyst inside the catalytic converter combines unburned hydrocarbons and carbon monoxide with oxygen to create carbon dioxide. If the catalytic converter melts it could possibly cause excessive again strain within the exhaust system, resulting in poor performance. Rust within the catalytic converter may result in exhaust leaks.
1. Increase the automobile according to directions listed in the owner’s handbook and support with jack stands.
2. Spray the retaining bolts with a penetrating oil comparable to WD-40. There are five bolts that connect the catalytic converter to the exhaust pipes: two in the entrance and three within the back.
3. Take away the bolts that join the front of the catalytic converter to the head pipe.
4. Take away the bolts that join the rear of the catalytic converter to the exhaust pipe.
5. Take away the catalytic converter from the vehicle.
6. Coat the threads of the retaining bolts with an anti-seize compound.
7. Raise the catalytic converter into place between the head pipe and exhaust.
8. Set up the bolts that join the rear of the catalytic converter to the exhaust pipe, however don’t tighten.
9. Set up the bolts that connect the front of the catalytic converter to the top pipe.
10. Tighten the bolts.
11. Decrease the vehicle.